Euphonix MixView CS3000 Manuale Utente Scaricare il pdf (Pagina 20)

Section 2: Monitoring Enhancements

1 - 18 Euphonix CS3000/2000 MixView 3.2 Software Supplement

the Glide times, press the DSC [Pnch] key, [F4] (Setup) and then [F3] (Glide):

The Glide feature is available on Upper and Lower Desk Fader objects as well

as CUBE Aux Send and Panner objects. Press [F1] (Desk) to set the glide time

for fader objects or [F3] (Cube) to set the glide time for CUBE objects. The

SpinKnob can be used to adjust the time values in single frame increments

from 1-999. Alternatively, the DSC Numeric Keypad can be used to enter a

specific value within the same range. Entering a value via the Numeric Keypad

locks out changes via the SpinKnob. This lockout is indicated by a small

rectangle next to the current SmartDisplay key designator as shown in the

previous menu figure for F1 (Desk). Press the [Enter] key to commit the

settings. Now let’s take a look at how to use the Glide feature.

With the [Glide] key lit, just punch-in and out as you normally would during a

standard automation pass. When you punch-out, glide will write a linear

automation move, for the designated period of time set in the Glide menu, to a

point where it seemlessly joins with underlying automation and punches out.

CUBE Glides operate in the same manner as Desk Glides, except that CUBE

Glide additionally supports the TRIM automation mode.

Glide allows for automated, seamless punch-outs of automation over a user

specified time interval. In Glide mode, any punch-out will terminate write

mode and return to read gradually by “gliding” from the last write level to the

automation level corresponding to the previously recorded underlying automa-

tion level, over the glide time interval. It is important to understand that after

you punch-out, the automation data continues to be written for the glide time

interval. The software generates the required data to connect the old and new

automation levels. When the object’s automation data level reaches the

underlying automation level, the object will then be punched out. If you punch

the object in again while the glide is in progress, the glide is aborted and you

again have control of the object.

The Glide feature is activated by pressing the DSC [Glide] key. Make sure that

there is a Title loaded and the DSC [Mix On] and [Fader A] keys are lit. To set

CUBE Automation Glide

Desk Automation Glide

3.2

3.1

Pnch

Fader Name Menu

F1 F2 F3 F4

Desk: 150 Cube: 150

Filtr Wthru Glide Auto

Touch Rel Tplt Setup

Automation Glide

3.1

Desk Glide operates only on Fader

Objects. All other desk Objects are

unaffected when Glide is active.

Desk Glide only operates in ABS

(Absolute) Mode. Glide is inactive

whenever a fader is in Trim Mode.

SIDE NOTE:

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26

Commenti su questo manuale

Nessun commento

Euphonix MixView CS3000 Manuale Utente Pagina 20

Commenti su questo manuale

Prodotti e manuali riguardandi Software Euphonix MixView CS3000