Euphonix MixView CS3000 Manuale Utente Scaricare il pdf (Pagina 6)

Section 1: Fader Enhancements

1 - 4 Euphonix CS3000/2000 MixView 3.2 Software Supplement

Fader dB Level

Displays

Fader Swap

F1 F2 F3

Fader Name Menu

F1 F2 F3 F4

dB Display Delay : 2.0 s

Fdr Attn DSC Delay

Clear Renum SS : Off

Fader Names

Prefs Menu

3.1

The display of fader dB levels has been enhanced. Previously, fader levels

were only displayed while in automation mode. Now, a fader’s dB level is

momentarily displayed in the fader name field of the Title Bar DSC display

screen. If your console is outfitted with CleaR Displays, fader dB levels for

each channel are displayed there as well. The dB Display Delay (the time it

takes the display to revert back to fader names) is adjustable from 0-9.9 secs

using the DSC SpinKnob. To set the delay timeout, press the QWERTY key-

board [F2] key, [F4] (down arrows) and then the [F4] (Delay) key:

The Fader Names Prefs menu controls how the fader dB levels are displayed.

By setting the ”Fdr” option with the [F1] (Fdr) key, a Moving Fader’s dB level is

displayed as long as your finger remains in contact with the fader, and contin-

ues to display for the duration of the specified delay timeout after contact with

the fader is ended. For non-motorized faders, the dB level is displayed as long

as the fader is in motion and continues to display for the specified delay

timeout after fader motion ceases. [F2] (Attn) and [F3] (DSC) control whether

levels are displayed when you press any channel attention or DSC Channel

Select key respectively. Levels will continue to display according to the delay

timeout for these buttons as well.

Fader Swap (a.k.a. fader flip) allows you to temporarily “exchange” the

functions of your Upper and Lower faders. When UF and LF banks are

swapped, all data relative to each fader block is swapped (i.e., mute, solo,

pan, fader, routing, source, mode and assign). Post fader associations such as

Post Fader Aux Sends and Fader Source Tracking maintain their proper assign-

ments based on UF and LF names. This means that an Aux set to follow UF for

channel 1 would correctly react to the Lower Fader on channel 1 when Swap is

active. This is because the UF block has been “swapped” in place of the LF

block.

The ability to swap the control of the Upper and Lower Fader banks is a handy

capability if your console is fitted with lower motorized faders. For instance, if

you want to make a touch-activated fader move on a channel’s non-motorized

upper fader, Fader Swap allows you to “virtually” swap the physical faders of

1 2 3 4 5 6 7 8 9 10 11 ... 25 26

Commenti su questo manuale

Nessun commento

Euphonix MixView CS3000 Manuale Utente Pagina 6

Commenti su questo manuale

Prodotti e manuali riguardandi Software Euphonix MixView CS3000